Electrical power UNITS FOR LIFT TABLE

Electrical power UNITS FOR LIFT TABLE one
Basic Description
This power unit is developed solely for that modest lift table,Consisting of high pressure gear pump, AC motor, multi-functional manifold, valves, tank, etc. This power unit has been broadly used within the sector of logistic devices such as minifork lift, scissors lift and ariel operating platforms. The lower-ing movement is controlled by the solenoid valve with all the speed managed from the adjustable needle valve.
Power UNITS FOR LIFT TABLE 2
Common Description
This power unit is designed exclusively to the medium lift table, Consisting of extremely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering motion is actived through the solenoid valve as well as the pace managed from the adjustable needle valve. Once the lift rises to a higher positoin, however the power supply is cut, the lowering movement is controlled from the guide override function.
Electrical power UNITS FOR LIFT TABLE three
Basic Description
This electrical power unit is developed exclusively to the substantial lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived from the solenoid valve as well as pace managed by a strain compensated flow management valve.
Energy UNITS FOR LIFT TABLE 4
Common Description
This energy unit is made exclusively for the big lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived from the solenoid valve as well as the pace controlled through the adjustable needle valve. When the lift rises to a substantial positoin, but the electrical power provide is reduce, the decreasing motion is controlled through the guide override perform.
Specific Notes
1. This power unit is of S3 duty cycle, which might only do the job intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean all the hydraulic elements concerned before installation of the electrical power unit.
three. Viscosity in the oil shoud be 15~46 cst,which must also be clean and absolutely free of impurities.N46 hydraulic oil is encouraged.
4. Oil modifying is required after the initial 100 operation hours,afterwards after every 3000 hours.
5. The energy unit shown is built to be mounted vertically.