SMR Gearbox Set up
Satisfactory overall performance is dependent upon suitable set up. lubrication and upkeep. consequently it is important that the guidelines in the installation and upkeep leaflet. provided with each and every gearbox. are followed very carefully. several of the essential aspects of belt and torque-arm set up are listed beneath.
1. Install pulley on gearbox input shaft as shut towards the reducer achievable, and mount reducer on driven shaft as shut to bearing as useful. failure to accomplish this can result in excess loads while in the input shaft bearings and output bearings and could cause their premature failure.
2. Install motor and wedge belt drive with all the belt pull at roughly 90° for the center line in between driven and input shafts. this may allow tensioning in the wedge belt drive with all the torque arm which must ideally be in stress. if output hub runs anti-clockwise. torque arm ought to be positioned the best.
3. lnstall torque-arm fulcrum on the rigid help so that the torque-arm will likely be at about right angles to your center line through the driven shaft as well as the torque arm case bolt. be certain there is enough 
take up in the turnbuckle for belt tension adjustment.
Keep shut.
Bell drive may very well be found in any easy postion. should the torque arm is always to be utilised to tighten the belts, the drive must be at about tight angle towards the line among the input and output shafts.
Bell drive could be found to your ideal if wanted.
If output hub rotates clock-wise. position belt drive and torque arm in opposite route to that shown in the illustration.
Torque arm and belt get up.
Torque arm can be mounted to the suitable if sought after.
SMR Gearbox Set up
Tags